Collated formwork nail SMA 116/10
Formwork nail collated SMA 116/10
NL-FORMWRK-MG-(SMA116/10)-47MM
Register now and access more than 125,000 products
- 10 nails per magazine
- With pre-determined breaking point
- For pin driver with magazine
- Observe processing instructions
All nails are suitable for secondary attachments (without technical approval). The maximum tensile forces of individual attachments are at the discretion of the user and must be determined with test attachments or pull-out tests.
Datasheets(X)
 | |
Material | Steel |
Surface | Zinc plated |
Shaft length (LS) | 47 mm |
Shank diameter (ØdS) | 3.7 mm |
Length of magazine (LG) | 93 mm |
Number of nails | 10 |
Suitable for paling-board thickness (Ld) | 22 mm |
Suitable for device type | Würth BST MA-75, Hilti DX 350, Hilti DX 36M, Hilti DX 460, Hilti DX5, Hilti DX 6 |
Last viewed
Support Plate mandrel
Clamping sleeve
Hex head screw with shank ISO 4014, steel 8.8, zinc-plated, blue passivated (A2K)
ASSY® 4 CSMP universal screw Steel zinc plated partial thread countersunk milling pocket head
Plus Quadro-L Vario hammer drill bit
Female thread plug-in nipple
EcoFresh S1PL safety shoe
External lens for helmet Solar II
3/4-inch impact socket wrench insert hexagon, metric, short
ASSY® 4 P CSMP universal screw Steel zinc plated partial thread with underhead thread milling pockets head